Best Practice Guidelines for Using a CBN Wheel


  1. Clean the machine thoroughly, and flush the coolant system. Recharge the coolant, making sure the coolant ratio is 50 to 1 or 1 and 1/2 cups per 5 gallons of water. (One cup = 8 fluid ounces) Use KW coolant only- PN 000-2115-05.
  2. Always start the grind with light down pressure, let the wheel do the work. Flood the wheel with coolant and then gradually increase the grind pressure. DO NOT overload the wheel, as premature wear will occur.
  3. No dressing or truing is typically required. The wheel will hold its edge even after grinding in a radius on a stepped flywheel.
  4. Let the wheel "Spark Out" without pressure for one to two minutes for maximum finish.

NOTE Use caution when grinding stepped or recessed flywheels. The flywheel should be centered using a dial indicator to ensure "0" radial run out. CBN will not tolerate side-impact, this will cause the wheel to break. Wheel breakage is not covered under warranty.








Irontite Brands

Check out our other sites!


Kwik-Way.com

Making the best Valve Refacer for over 100 years.
Made in the U.S.A. and built to last generations.


Irontite.com

Irontite Products Inc. professional diesel engine repair tooling for casting repairs, injector sleeve replacement, and cooling system additives.
When you need it to be IronTite!



Need to order supplies or OEM replacement parts?